200 Amp Panel Upgrade Los Angeles
Your 100-amp panel wasn't designed for EV chargers, heat pumps, and modern appliances. Upgrade to 200 amps for the power your home needs today.
Is Your Panel Keeping Up With Your Home?
Most homes built before 2000 have 100-amp service. That was enough for lights and a few appliances. Today's homes need more:
⚡ EV Charger Ready
Level 2 EV chargers draw 30-50 amps. A 200-amp panel gives you capacity for charging plus everything else.
❄️ Heat Pump HVAC
Modern heat pump systems require dedicated 240V circuits. A 200-amp panel handles the load safely.
🏠 Home Value
A 200-amp panel is expected by buyers and inspectors. Upgrading before selling can prevent deal-killing repairs.
📋 Code Compliance
NEC 2020 requires 60-amp minimum service for new construction. Upgrading brings older homes closer to current code.
How We Upgrade Your Panel
Load Calculation
We perform a NEC Article 220 load calculation to confirm you need 200 amps. Some homes can add capacity without a full upgrade.
Permits
We pull the electrical permit with LADBS. This includes the service entrance, panel, and grounding work.
Shut Down & Swap
We coordinate with LADWP for service disconnect, remove the old panel, install the new 200A panel, and reconnect.
Inspection & Power-On
LADBS inspects the installation. Once approved, we coordinate with LADWP to restore service.
200 Amp Panel Upgrade FAQ
How much does a 200 amp panel upgrade cost in Los Angeles? +
A 200-amp panel upgrade typically runs $2,500-$5,000 depending on your existing service, panel location, and whether the meter base and weatherhead also need replacement. All estimates include permits and LADBS inspection.
Do I need a 200 amp panel? +
If you have a 100-amp panel and are adding an EV charger, heat pump HVAC, or major appliances, you likely need a 200-amp upgrade. We perform a load calculation during your free estimate to confirm.
How long does a panel upgrade take? +
Most 200-amp panel upgrades take 1-2 days. You will be without power for 4-8 hours during the panel swap. We schedule a same-day inspection when possible.
Will I need to upgrade my meter base? +
If your existing meter base is rated for 100 amps or is damaged/corroded, it must be upgraded to handle 200 amps. We inspect the meter base during the estimate and include it in the quote if needed.
Do I need a permit for a panel upgrade? +
Yes. Los Angeles requires an electrical permit for any panel upgrade. Our permit fee is included in your estimate. We handle the entire permitting process with LADBS.
Get Your Free Panel Upgrade Estimate
We'll perform a load calculation, inspect your existing service, and provide a written estimate — no obligation.
Call (818) 302-5614